The URL can be used to link to this page

Home My WebLink AboutPL 2017-00063 New Retail Building CITY OF OAK PARK HEIGHTS PERMIT NO.: 2017-00063 14168 OAK PARK BLVD N. #2007 OAK PARK HEIGHTS, MN 55082-2007 DATE ISSUED: 03/15/2017 (651)351-1661 FAX: (651) 439-0574 ADDRESS : 13181-13197 60TH ST N PIN : 05.029.20.22.0019 LEGAL DESC : BRACKEY 4TH ADDITION : LOT 1 BLOCK 1 PERMIT TYPE : PLUMBING PROPERTY TYPE : COMMERCIAL CONSTRUCTION TYPE : NEW CONSTRUCTION VALUATION : $ 22,800.00 NOTE: CONSTRUCT PER APPROVED PLANS,IN COMPLIANCE WITH MN 01-05-2017 STATE PLAN REVIEW(PLB1611-00149),WITH ALL MN STATE BUILDING AND PLUMBING CODE REQUIREMENTS&LOCAL ORDINANCES. PLUMBING FOR LOT 1 RETAIL SHELL. INCLUDES CHARGE FOR TWO 1-1/2"WATER METERS FOR DOMESTIC AND IRRIGATION. VALUE OF PLUMBING 22800 WATER METER FEE 2962 APPLICANT PLUMBING-COMMERCIAL 228.00 PLUMBING STATE SURCHARGE COMMERCIAI 11.40 VOSS UTILITY&PLUMBING WATER METER 2,961.70 P.O. BOXWATER SALES TAX 211.02 HANOVER, MN 55341- (763)497-4577 WATER FUND 35.00 Minnesota State License#: PLUM-PM060679 STORM SEWER FUND 35.00 TOTAL 3,482.12 Payment(s) OWNER CHECK 033323 3,482.12 KRUEGER LANE LLC 4999 FRANCE AVE STE 216 MINNEAPOLIS, MN 55410- AGREEMENT AND SWORN STATEMENT The work for which this permit is issued shall be performed according to:(1)the conditions of this permit;(2)the approval plans and specifications;(3)the applicable city approvals,Ordinances,and Codes;and,(4)the State Building Code.This permit is for only the work described,and does not grant permission for additional or related work which requires separate permits. This permit will expire and become null and void if work is not started within 180 days,or if work is suspended or abandoned for a period of 180 days any time after work has commenced. The applicant is responsible for assuring all required inspections are requested in conformance with the Minnesota State Building Code. SEPARATE PERMITS REQUIRED FOR WORK OTHER THAN DESCRIBED ABOVE. 443 Lafayette Road N. MINNESOTA DEPARTMENT OF (651)284-5005 St. Paul, Minnesota 55155 1-800-DIAL-DLI www.dli.mn.gov LABOR & INDUSTRY TTY: (651)297-4198 Division of Construction Codes and Licensing REPORT ON PLUMBING PLANS PROJECT: Oak Park Heights Retail Building Lot 1 Interior, 6000 Krueger Lane, Oak Park Heights,Washington County,Minnesota,Plan No. PLB1611-00149 SUBMITTER: Voss Utility&Plumbing Inc., PO Box 240,Hanover,MN 55341 Plans Dated: November 14, 2016 Date Received: November 18, 2016 Date Approved: January 5, 2017 This review is limited to the provisions of the Minnesota Plumbing Code, Minnesota Rules, Chapter 4714 and assumes the data on which the design is based are correct. Approval is contingent upon meeting the requirement(s)listed below. A copy of the approved plans and this report must be retained at the project location. INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of the Minnesota Plumbing Code. No plumbing work may be covered prior to inspection. The contractor/installer must obtain all required inspection permits from the city of Oak Park Heights Building Official. REQUIREMENT(S): 1. All plumbing shall be installed in accordance with the 2015 Minnesota Plumbing Code(see Minnesota Rules, Chapter 4714). 2. A building's vent pipes must have total cross-sectional area not less than the area of the largest required building sewer(see Minnesota Rules, Chapter 4714, Section 904.1). 3. All floor drains must be individually vented(see Minnesota Rules, Chapter 4714, Sections 418.2 and 1002.1). The trap to vent distance must meet the requirements of Table 1002.2. This shall include the floor drain shown on Detail 6/P2. 4. There is a small length of 6 inch horizontal rainwater leader prior to a 6 inch vertical downspout that is serving 6,722 square feet of roof area on Detail 3/P2. Since a 6 inch horizontal leader can only accommodate 5,350 square feet at a slope of 1/8 inch per foot,this leader is undersized. 5. If a hydromechanical grease interceptors is installed it must be approved by the administrative authority, may serve only fixtures discharging greasy waste, and must comply with Minnesota Rules, Chapter 4714, Section 1014.2. No food waste disposer or dishwasher may be connected unless specifically required or permitted by the administrative authority. The installation must include: a. The interceptor should comply with ASME A112.14.3, CSA B481, or PDI G-101 and be so marked on a permanent identification label. b. The minimum interceptor rating in gallons per minute is the volume of the connected sink compartments in cubic inches multiplied by a fill factor of 0.75,divided by 231 and adding any equipment discharge. For a two-minute drain period, divide the sink calculation by two and add any equipment discharge. c. The interceptor and flow control must be readily accessible. Vents serving external flow controls must connect to the sanitary vent system. d. The interceptor discharge line must be vented. e. A 15-minute manometer test at 1-inch of water column per Section 712.5 is required. f. The interceptor must be maintained in efficient operating condition. This information can be provided to you in alternative formats(Braille,large print or audio). An Equal Opportunity Employer Oak Park Heights Retail Building Lot 1 Interior Plumbing Plan No.PLB1611-00149 Page 2 January 5,2017 6. In no case shall water from roofs be allowed to flow upon the public sidewalk(see Minnesota Rules, Chapter 4714, Section 1101.1). Verify that the discharge from all rainwater conductors will meet this requirement. 7. The installation of reduced pressure zone assemblies,double check valve assemblies,pressure vacuum breakers, spill-proof vacuum breakers,reduced pressure detector fire protection assemblies,or double check detector fire protection assemblies is permitted only when a testing and inspection program acceptable to the administrative authority is provided(see Minnesota Rules, Chapter 4714, Section 603.5.23). The administrative authority and water purveyor must be notified prior to installation. Devices must be tested upon initial installation and not less than annually,and records must be kept. Installations must be at least 12 inches and not more than 5 feet above the finished floor or ground level unless a permanent platform for access is provided. A backflow prevention fact sheet may be viewed at: http://www.dli.mn.gov/CCLD/PDF/fs_backflow.pdf 8. Public-use lavatories must have an ASSE 1070 mixing valve limiting the hot water temperature to 110 degrees Fahrenheit or less(see Minnesota Rules,Chapter 4714, Section 421.2). NOTE(S): 1. The scope of this project consists of constructing a new building. The plumbing installation includes a water heater,floor drains,a mop sink,a water cooler,two lavatories,two tank type water closets,and primary and overflow roof drains. 2. The building will be served by new municipal sewer and water services reviewed under PLB1608-00139. 3. The plans and specifications were prepared by a licensed plumber. Only the plumber who has prepared the plans may use the plans for construction. If another plumber is contracted to install the plumbing,they must submit their own plans and specifications for the project. Authorization for installation may be withdrawn if construction is not undertaken within one year. Additional recommendations or requirements may be made if changed conditions or additional information make improvements necessary. The current Minnesota Plumbing Code,Chapter 4714,and related information can be found at: http://www.dli.mn.gov/CCLD/Plumbing.asp Approved: go/4/ Bradley Williams, P.E. Public Health Engineer Plumbing Plan Review and Inspections Unit 651/284-5836 Bradley.Williams@state.mn.us cc: Voss Utility&Plumbing Inc. City of Oak Park Heights Building Official File