The URL can be used to link to this page

Home My WebLink AboutPL 2001-00142 - Pony Express Auto Wash r'ty of Oak Park Heightr—, METER NO: 141 Oak Park Blvd. N. #2( Oak Park Heights , MN 55082-2007 PERMIT NO. : 0100142 651/439-4439 FAX: 651/439-0574DATE ISSUED: 07/05/2001 Address 5970 Neal Ave N PIN : TO-010-01 Legal Desc : Subdivision JACOB 2ND ADDITION : Lot 02 Block 01 Parcel Permit Type : Plumbing Property Type : Commercial Construction Type : New Construction Activity Value Of Plumbing 53485 NOTE: CONSTRUCT PER APPROVED PLANS. MUST COMPLY WITH ALL MN STATE BUILDING AND PLUMBING CODE REQUIREMENTS. 6/15/01 - Water meter fee paid for with new construction permit # 1-83. This permit issued for plumbing installation at Pony Express Auto Wash. OWNER PLUMBING-COMMERCIAL $534 .85 William Costa/pony Express Auto Was PLUMBING STATE SURCHARGE COM $0.50 2490 Stagecoach Trail N Total $535.35 Stillwater, MN 55082- Paid with check # 1358 APPLICANT (651/641-5955) FOREMOST MECHANICAL CORP 501 W. Lawson Ave St. Paul, MN 55117 AGREEMENT AND SWORN STATEMENT The work for which this permit is issued shall be performed according to : (1) the conditions of this permit; (2)the approval plans and specifications; (3)the applicable city approvals, Ordinances, and Codes; and, (4) the State Building Code.This permit is for only the work described, and does not grant permission for additional or related work which requires separate permits.This permit will expire and become null and void if work is not started within 180 days, or if work is suspended or abandoned for a period of 180 days any time after work has commenced. The applicant is responsible for assuring all required inspections are requested in conformance with the Minnesota State Building Code. SEPARATE PERMITS REQUIRED FOR WORK OTHER THAN DESCRIBED ABOVE. • i) 1 MINNESOTA DEPARTMENT OF HEAL S' 41 2 0 200' Division of Environmental Health 1 _ REPORT ON PLANS Plans and specifications on plumbing: Pony Express Auto Wash, 5970 Neal Avenue North, •.1 '; . Hei Jits, Washington County, Minnesota,Plan No. 013411 OWNERSHIP: SUBMI ll'ER(S): Foremost Mechanical Corporation, 501 West Lawson Avenue, St. Paul, Minnesota 55117 Plans Dated: April 19,2001;April 23,2001 Date Received: May 24,2001 Date Reviewed: June 14, 2001 SCOPE: This review is limited to the design of this particular project only insofar as the provisions of the Minnesota Plumbing Code, as amended,apply, and does not cover the water supply or sewerage system to which this plumbing system is connected. The review is based upon the supposition that the data on which the design is based are correct, and that necessary legal authority has been obtained to construct the project. The responsibility for the design of structural features and the efficiency of equipment must be taken by the project designer. Approval is contingent upon satisfactory disposition of any requirements included in this report. Special care should be taken to insure that the material and installation of the plumbing system are in accordance with the provisions of the Minnesota Plumbing Code. A copy of the approved plans and specifications should be retained at the project location for future reference. Enclosed is a copy of the report and transmittal letter to be forwarded to the project owner. INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of the Minnesota Plumbing Code. As specified in Minnesota Rules, part 4715.2830, no plumbing work may be covered prior to completing the required tests and inspections. Provisions must be made for applying an air test at the time of the roughing-in inspection as outlined in Minnesota Rules,part 4715.2820, subpart 2, of the code. A manometer test, as specified in Minnesota Rules,part 4715.2820, subpart 3, is required at the time of the finished plumbing inspection. It is the responsibility of the contractor/installer to notify the State Health Department when the installation will be ready for a test and inspection. To schedule inspections,contact the state plumbing standards representative for your region, or call the metro office at 1-800-926-6216, or Gary Topp at 651/215-0841. REQUIREMENT(S): 1. The flammable waste trap shall be constructed in accordance with the Minnesota Plumbing Code, Minnesota Rules,part 4715.1120. The interceptor shall include: a. At least 3 feet of depth below the invert of the discharge pipe. b. A water seal of not less than 3 inches on the inlet and not less than 18 inches on the outlet. c. The vent must rise vertically or within 45 degrees of the vertical to a point at least 6 inches above the interceptor. The vent shall be constructed of approved metallic pipe material. d. Drains that discharge into the interceptor shall be the dry-pan-type 2. The plans indicate the installation of two 6-gallon water heaters above the ceiling panel. Tools must not be required to gain access to the water heaters(see Minnesota Rules,part 4715.2240). It is recommended that the relief valve discharge pipes be routed independently to a point of safe disposal below the ceiling. Pony Express Auto Wash Plumbing Plan No. 013411 Page 2 June 14, 2001 3. The vent serving the floor drain in the boiler room must be at least 2 inches in size (see Minnesota Rules, part 4715.2500, subpart 3). 4. A cleanout must be provided near the connection between the building drain and the building sewer (see Minnesota Rules, part 4715.1000). 5. Double wyes may not be used for drainage fittings in the horizontal position (see Minnesota Rules, part 4715.2420, subpart 3). Proper pipe slope cannot be maintained on both of the offset branches. 6. The vent pipe opening from a soil or waste pipe may not be below the weir of the trap. The fixture drain lines must connect to the vertical sanitary drain with a tee connection rather than a wye connection as indicated in the waste and vent riser diagrams (see Minnesota Rules, part 4715.2620, subpart 2). 7. The installation of reduced pressure zone backflow preventers is permitted only when periodic testing is done by a trained backflow preventer tester acceptable to the administrative authority. Testing intervals shall not exceed one year, and records must be kept. All devices must be tested after initial installation to assure that debris from the piping installation has not interfered with the functioning of the device. The devices shall be overhauled at least once every five years. The installation of new backflow preventers must be at least 12 inches, but not more than 6 feet above the finished floor or ground level. 8. PVC materials used for building sewers must comply with Minnesota Rules, part 4715.0530. 9. The plumbing system shall be tested in accordance with Minnesota Rules, part 4715.2820. 10. The water piping system shall be disinfected in accordance with Minnesota Rules, part 4715.2250. NOTE(S): 1. The scope of this project consists of the construction of a new building. The plumbing installation includes three restrooms and a flammable waste interceptor. 2. This facility is served by new municipal water and sewer service connections. Authorization for construction in accordance with the approved plans may be withdrawn if construction is not undertaken within a period of two years. The fact that the plans have been approved does not necessarily mean that recommendations or requirements for change will not be made at some later time when changed conditions, additional information, or advanced knowledge make improvements necessary. Pony Express Auto Wash Plumbing Plan No. 013411 Page 3 June 14, 2001 Approved: Bradley C. rickson Public Health Engineer Environmental Health Section P.O. Box 64975 St. Paul, Minnesota 55164-0975 651/215-0853 BCE:Iss Enclosure cc: Project Owner Foremost Mechanical Corporation Mr. Jim Butler, Plumbing Inspector Plumbing Unit File