Loading...
HomeMy WebLinkAboutPL 2004-00523 Tenant Space Build Out - Trade Secret .ity of Oak Park Heigh METER NO: 14168 Oak Park Blvd. N. #2007 PERMIT NO. : 0400523 Oak Park Heights, MN 55082-2007 651/439-4439 FAX: 651/439-0574 DATE ISSUED: 12/17/2004 Address 13331 60th St N PIN : T0-040-11 Legal Desc : Subdivision THE SHOPPES OF OAK PARK HEIGHTS 2ND : Lot --2 Block 001 Parcel Permit Type : Plumbing Property Type : Commercial Construction Type : New Construction Activity : Tenant Space Plumbing Build Out Value Of Plumbing 0 NOTE: CONSTRUCT PER APPROVED PLANS. MUST COMPLY WITH ALL MN STATE BUILDING AND PLUMBING CODE REQUIREMENTS. PERMIT ISSUED FOR WASTE VENT, WATER TO 2 SHAMPOO SINKS, WASHER BOX AND ONE 2" FLOOR DRAIN. OWNER PLUMBING-COMMERCIAL $75.00 Shoppes Of Oak Park Heights Llc PLUMBING STATE SURCHARGE COM $0.50 200 West Hwy 13 Total $75.50 Burnsville, MN 55337- Paid with check # 74169 APPLICANT (651/464-2988) COMMERCIAL PLUMBING & HEATING INC 24428 Greenway Ave Forest Lake, MN 55025 AGREEMENT AND SWORN STATEMENT The work for which this permit is issued shall be performed according to : (1) the conditions of this permit; (2)the approval plans and specifications; (3)the applicable city approvals, Ordinances, and Codes; and, (4) the State Building Code.This permit is for only the work described, and does not grant permission for additional or related work which requires separate permits.This permit will expire and become null and void if work is not started within 180 days,or if work is suspended or abandoned for a period of 180 days any time after work has commenced. The applicant is responsible for assuring all required inspections are requested in conformance with the Minnesota State Building Code. SEPARATE PERMITS REQUIRED FOR WORK OTHER THAN DESCRIBED ABOVE. • • © E 0\\01' MINNESOTA DEPARTMENT OF HEALTH DNOV 2 2004 j Division of Environmental Health REPORT ON PLANS Plans and specifications on plumbing: Trade Secret,Highway 36 and Krueger Lane,Space No. 101, Oak Park Heights,Washington County,Minnesota,Plan No. 051640 OWNERSHIP: Soloman Real Estate Group, 1907 East Wayzata Boulevard,No. 140,Wayzata, Minnesota 55391 SUBMITTER(S): Commercial Permits,Inc., 2620 63rd Street,Fennville,Michigan 49408 Plans Dated: Date Received: October 27,2004 Date Reviewed: November 4,2004 SCOPE: This review is limited to the design of this particular project only insofar as the provisions of the Minnesota Plumbing Code,as amended,apply, and does not cover the water supply or sewerage system to which this plumbing system is connected. The review is based upon the supposition that the data on which the design is based are correct,and that necessary legal authority has been obtained to construct the project. The responsibility for the design of structural features and the efficiency of equipment must be taken by the project designer. Approval is contingent upon satisfactory disposition of any requirements included in this report. Special care should be taken to insure that the material and installation of the plumbing system are in accordance with the provisions of the Minnesota Plumbing Code. A copy of the approved plans and specifications should be retained at the project location for future reference. A set of the identified plans and specifications is being returned to Commercial Permits,Inc. INSPECTIONS: All plumbing installations must be tested and inspected in accordance with the requirements of the Minnesota Plumbing Code. As specified in Minnesota Rules,part 4715.2830,no plumbing work may be covered prior to completing the required tests and inspections. Provisions must be made for applying an air test at the time of the roughing-in inspection as outlined in Minnesota Rules,part 4715.2820,subpart 2,of the code. A manometer test, as specified in Minnesota Rules,part 4715.2820, subpart 3,is required at the time of the finished plumbing inspection. It is the responsibility of the contractor/installer to notify the Minnesota Department of Health when an installation for a state contract job,licensed facility, or project in an area where there is no local administrative authority is ready for an inspection and test. To schedule inspections,contact the state plumbing standards representative for your region, or call the metro office inspection hotline at 1-800-926- 6216(7:30 a.m. to 9 a.m.), or 651/215-0836(8 a.m.to 9 a.m.) on Monday,Wednesday or Friday. REQUIREMENT(S): 1. Water supply connections to fixtures or equipment which have submerged inlets,or inlets below the spill line of the fixture or equipment,must be provided with an air gap arrangement, approved backflow preventer or backflow preventer assembly as specified in Minnesota Rules,part 4715.2000 and part 4715.2010. This shall include the clothes washer,the trap primer, and the hair wash sinks if equipped with spray-rinse hoses. 2. It is recommended that a cleanout be provided where new waste and vent piping connects with existing plumbing to facilitate required testing of the new installation. f €k Trade Secret s Plumbing Plan No. 051640 Page 2 ... November 4, 2004 3. Materials used for water distribution piping must comply with Minnesota Rules,part 4715.0520.All solder and flux used for the potable water distribution systems shall contain less than 0.2 percent lead. Use of 50-50 solder or flux containing more than 0.2 percent lead is prohibited in potable water distribution systems. Any solder other than 95-5 tin-antimony or 96-4 tin-silver must be specifically approved by the administrative authority prior to use(see Minnesota Statutes, Section 326.371). Joints to be soldered must be properly fluxed with noncorrosive paste-type flux complying with ASTM Standard B813-00. 4. Materials used for drain,waste, and vent systems must comply with Minnesota Rules,part 4715.0570 through part 4715.0600. If plastic pipe is used for the drain,waste and vent system: a. ABS plastic pipe shall comply with ASTM Standard D 2661 or F 628. b. PVC plastic pipe shall comply with ASTM Standard D 2665,D 2949,F 891. c. It must be installed in accordance with Minnesota Rules,part 4715.0580(F)and part 4715.0600. Above-grade horizontal runs of plastic waste and vent pipe cannot exceed 35 feet in total length. Above-grade vertical stacks constructed of plastic pipe may exceed 35 feet in total height only if an approved expansion joint is used. d. Solvent weld joints in PVC and CPVC pipe must include use of a primer which is of contrasting color to the pipe and cement(see Minnesota Rules,part 4715.0810, subpart 2). 5. The plumbing system shall be tested in accordance with Minnesota Rules,part 4715.2820. 6. The water piping system shall be disinfected in accordance with Minnesota Rules,part 4715.2250. NOTE(S): 1. The scope of this project consists of the remodeling of an existing building. The plumbing installation includes two hair wash sinks,a clothes washer,and a floor drain. 2. This facility is served by existing municipal water and sewer service connections. Authorization for construction in accordance with the approved plans may be withdrawn if construction is not undertaken within a period of two years. The fact that the plans have been approved does not necessarily mean that recommendations or requirements for change will not be made at some later time when changed conditions, additional information,or advanced knowledge make improvements necessary. Approved: Bradley C.-Erickson Public Health Engineer Environmental Health Services Section P.O.Box 64975 St.Paul,Minnesota 55164-0975 651/215-0853 BCE:sas cc: Commercial Permits, Inc. Soloman Real Estate Group Mr. Jim Butler,Plumbing Inspector ector File